BEST SELLERS

In Server & Components

- Great for the price - USB 2 and 3 front headers - 5.25" device slot, very useful to add hot swappable drives

Direct replacement for OEM battery. But bee sure to verify your OEM battery's amp hours and voltage specs before ordering as batteries for other APC models may look alike but may not meet your particular APC backup model's performance specs.

Loaded up VMware ESXi 8.x ISO via Remote KVM IPMI and installed without an issue for an Asrock AMD R9 5900X build.

Fast. Copying from my old computer to this one across gigabit ethernet uses well over half the available bandwith. The write speed is just so much better than the on board Intel raid. For another 250, you can add another 15 or 20 drives if you have that need, search for "intel raid expander." And did I say fast. Good tech support.

work real good gives more drive space

This UPS was a great solution to support networking equipment (modem, router, switch) that I installed in my basement. It has lots of outlets and the size of the unit was perfect for mounting on the network wall panel.

Works LSI Logic controllers just work better than anything else on the market. Perform great, and work reliably.

I work in music recording/mixing studio environments and am extremely fussy about equipment that generates noise. I'm pleased to say that after several months of continuous use, this Li-Ion APC rack unit met and possibly exceeded expectations. When in ideal conditions, the unit is literally silent. No fan noise, no hum, no buzz. The only time noise has been observed is either when the unit is charging (due to a power failure) where very minimal self-noise is inevitable, or in an under-voltage condition (117V or under) where the internal circuitry activates in order to boost the output voltage. In comparison to APC's own legacy units (ie: 2U 750VA-1500VA lead acid monsters) which I have been using for over 15 years - they had frequent noticeable cooling fan noise, and could produce undesirable self-noise when approaching maximum load. And anecdotally, I have had one or two units fail over the years and drop the load.

Easy set up for a NAS backup power supply....just plug in and energize.

The plugs are aligned in such a way, that most wall-warts can be used with it, without one crowding out the other. I use this to power my guitar stomp boxes in my home studio. Each stomp-box has their own wall-wart/converter. I am able to run 6 pedals with no crowding, with 2 slots to spare. The Belkin is also built really well, with a long (8'), thick power cord. It is a heavy duty strip. The built-in 2500 joule' surge suppressor is more than adequate for most needs as well, offering good protection for any electronics plugged into the strip. I expect years of trouble-free use.

Well built