BEST SELLERS

In Server & Components

Appears to be an OEM battery, simple directions on how to replace it. It's expensive, but my last battery lasted me 5 years and it's nice to have the piece of mind during a power outage.

I thought that I had received the wrong drive. Acutally I had the wrong cable. And I should have known better. Once I got the correct cable, the boards work.

Good fit, easy install. Hardware was included. I used this mount to install an internal card reader in a 5.25" drive bay and it worked as intended.

Small and works great for the modem and router and other small power use.

Plenty of outlets, long cable. Nice to have some protection for thousands of dollars worth of computer tech and monitors.

Super fast file transfer Recognized all of my 24 WD 12TB HDDs upon drivers install without any issues. Comes in IT mode firmware preinstalled so great right out of the box. Extremely well constructed.

I work in music recording/mixing studio environments and am extremely fussy about equipment that generates noise. I'm pleased to say that after several months of continuous use, this Li-Ion APC rack unit met and possibly exceeded expectations. When in ideal conditions, the unit is literally silent. No fan noise, no hum, no buzz. The only time noise has been observed is either when the unit is charging (due to a power failure) where very minimal self-noise is inevitable, or in an under-voltage condition (117V or under) where the internal circuitry activates in order to boost the output voltage. In comparison to APC's own legacy units (ie: 2U 750VA-1500VA lead acid monsters) which I have been using for over 15 years - they had frequent noticeable cooling fan noise, and could produce undesirable self-noise when approaching maximum load. And anecdotally, I have had one or two units fail over the years and drop the load.

Fairly small - this was needed for the location these were being installed Powerful enough - they are only covering 1 PC and 1 other piece of equipment on each. Only need to last 45 seconds before house generator kicks in.

The plugs are aligned in such a way, that most wall-warts can be used with it, without one crowding out the other. I use this to power my guitar stomp boxes in my home studio. Each stomp-box has their own wall-wart/converter. I am able to run 6 pedals with no crowding, with 2 slots to spare. The Belkin is also built really well, with a long (8'), thick power cord. It is a heavy duty strip. The built-in 2500 joule' surge suppressor is more than adequate for most needs as well, offering good protection for any electronics plugged into the strip. I expect years of trouble-free use.

Nice build quality, decent fit and finish, reasonable beveled edges. No sharp bits to get cut on.